Archives
Tytera MD-380 USB Driver v3.0.1
Tytera MD-380 CPS Programming Software v1.29
Tytera MD-380 CPS Programming Software v1.30
Tytera MD-380 CPS Programming Software v1.32
Tytera MD-380 CPS Programming Software v1.34
CHIRP Installer 20210724
CHIRP is a free, open-source tool for programming your amateur radio
CHIRP Installer 20211105
CHIRP is a free, open-source tool for programming your amateur radio
Yaesu FT-817/857/897 Extended TX Software WidebanderV4
There are a few programs that do this job but none easier than ‘M0BMN’s’ WidebanderV4.
SIMOCO SRM9020 RADARC LowBand 4Metres Mobile October 2008
SIMOCO SRM9030 RADARC UHF 70cms Mobile
Ham Radio Deluxe Full v4.1 beta build 2321
Icom IC-2820 New Product Information January 2007
Icom IC-2820 Brochure 2007
Icom IC-2820H Instruction Manual
Yaesu FT-817/857/897 Extended TX Software WidebanderV4
There are a few programs that do this job but none easier than ‘M0BMN’s’ WidebanderV4.
Yaesu FT817/857 Soft Jump Software by VK2IT V0.2
by Peter May, VK2IT, vk2it@tpg.com.au
This program uses undocumented CAT commands to read or update the EEPROM
in the Yaesu FT817, FT857, and FT897 Radios. The soft jumper settings are stored
in location 4 and 5 of the EEPROM. Power the radio off and on to activate
the new settings. If you do a reset of the radio, you will have to run
this program again to rewrite the values
The program assumes that the radio CAT rate is set to 38400 baud
Yaesu FT817/857 Soft Jump Software by VK2JCG
by Peter May, VK2JCG, vk2jcg@yahoo.com.au
This program uses undocumented CAT commands to read or update the EEPROM
in the Yaesu FT817 and FT897 Radios. The soft jumper settings are stored
in location 4 and 5 of the EEPROM. Power the radio off and on to activate
the new settings. If you do a reset of the radio, you will have to run
this program again to rewrite the values